Post-deploy message to the user

After az webapp deploy / azd deploy returns successfully, the skill is done. Do not run any further verification commands.

Hard rules

• ⛔ Never run az webapp log tail as a "confirm startup" step — logs are often quiet for 1–2 min during build/warm-up; silence is not a failure signal.
• ⛔ Never run curl, Invoke-WebRequest, wget, or any HTTP request against the deployed URL — first request often 502s or times out on a healthy deploy.
• ⛔ Never present an early 5xx or quiet log stream as a deploy failure — the deploy succeeded; the platform just isn't warm yet.
• ✅ Always give the user the URL, the wait expectation, and the log command, then stop.

Message template — standard (Flask / Django / FastAPI)

Use this when Step 2 detected a known framework (flask, django, or fastapi). Print exactly this (substituting the real values) as the final output of the skill, then end the turn:

✅ Deployment complete.

🌐 App URL: https://<app>.azurewebsites.net
   It can take 2–3 minutes for the site to be reachable while App Service finishes
   warming up the container. Open it in your browser after a short wait.

📜 If you want to watch live logs:
   az webapp log config -n <app> -g <rg> --application-logging filesystem --level information
   az webapp log tail -n <app> -g <rg>
   (The first command is a one-time prereq on a fresh app — without it the stream stays empty.)

Message template — unknown framework

Use this when Step 2 detected wsgi-generic, asgi-generic, or unknown (i.e. not Flask, Django, or FastAPI). The code is already deployed and SCM_DO_BUILD_DURING_DEPLOYMENT=true is set, but Oryx will not know how to start the app until the user sets a startup command. Print this instead:

✅ Code deployed — but framework not detected.

🌐 App URL: https://<app>.azurewebsites.net
   It can take 2–3 minutes for App Service to finish building and start the
   container. The site will likely return an error page until you set a
   startup command (next step).

⚠️  We could not detect Flask, Django, or FastAPI in your project, so no
   startup command was set automatically. Set one with:

   az webapp config set -n <app> -g <rg> \